Changes to Step #24

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] P-Offset Cont.
[* 5] Toggle the adjustment increment to 0.1mm.
[* 4] Place a sheet of paper under the nozzle.
[* 7] Lower the nozzle (raise the bed) in 0.1mm increments until the sheet of paper is trapped between the nozzle and platform. Feel free to drop down to 0.01mm for finer tuning.
-[* 8] In our case, we had to lower the nozzle by just 0.1mm before this happened.
+ [* 8] In our case, we had to lower the nozzle by just 0.1mm before this happened.