Changes to Step #7
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Troubleshooting |
|---|---|
| + | [* 10] If after a 2-3 minutes you do not get your hotend fan spinning, power off, wait 10 seconds and power on again. |
| + | [* 10] If your touch screen shows an Illegal flash app error: |
| + | [* 1] 1. Wipe the SD card and put an empty text file named reset.txt onto it. |
| + | [* 1] 2. Power off the printer, insert the SD card into the display and power on again. |
| + | [* 1] 3. After the reset, wipe the SD card, and copy the firmware files again and retry the installation. |