Proforge 3.5 Upgrade
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
Introduction
Details
Guide Steps
Review
Quiz
Insert the SD card into the Raspberry Pi and power up your printer.
Give the Pi a few minutes to boot up.
In your browser type mainsail.local to bring up the printers control panel.
Make sure that your device is connected to the same network as the printer. You should have set the network name and password in the previous step.
If everything is setup correctly you should be greeted with this screen. There are a few more steps to complete in order to set up Klipper.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.