I tried the option “DEACTIVATE_SERVOS_AFTER_MOVE” in the “configuration.h”. (Not use Makerteck's official firm)
In my environment, new problem was occur. When hotends were in situation heating up, no problem. But, in the stable stage, affect by PID's control noize, servo was starting unexpect movement.
I tried the option “DEACTIVATE_SERVOS_AFTER_MOVE” in the “configuration.h”. (Not use Makerteck's official firm)
In my environment, new problem was occur. When hotends were in situation heating up, no problem. But, in the stable stage, affect by PID's control noize, servo was starting unexpect movement.
I will check out this problem more.
Maybe I am facing same problem.
My servo's shaft became ratting, and I checked out this problem, the hole that shaft through become wide.
I have no idea, if this problem's cause was heat or revolve power or etc.
I will buy same type servo, and replace it.
And, I think servo arm's hole design is not good.
It just simple hole, so if need too much power for DSH switching, hole slip easily.
My one of thermistor is broken. (I selected High/High Option)
When I tried this step, Printer was halt.
One side temp was rise, but the other side temp was not change.
Of cause, both side heater block was hot. But current temp was not change.
Then I swaped the thermistor’s connector, temp rising side was swapped.
So, I want to buy new sensor, what I should buy?
My probe mount's thread insert was slided, and couldn't stable probe.
This parts should has been designed that insert was inside.
I designed new probe mount that use with Probe's original M12 Nut, then I printed with other 3D printer.
My designed parts is work correctly, and probe is stabled more strong.