Revision to Dual Switching Hotend v2
| The Switching Hotend is available [https://www.makertech3d.com/products/dual-switching-hotend-v2-non-proforge|here]. | |
| + | |
| + | All of the downloads are available in the GitHub repository [https://github.com/Makertech3D/Dual-Switching-Hotend-v2|here]. |
| == Hardware Requirements == | |
| == Safety Notice == | |
| - | Operate the |
| + | Operate the DSH in a well ventilated, open and dry environment. |
| Be aware of the moving parts, there is a pinching hazard. | |
| - | Be cautious of the Hotend, it can reach temperatures exceeding |
| + | Be cautious of the Hotend, it can reach temperatures exceeding 400 degrees Celsius, this is hot enough to cause severe burns. Even after operation, the hotends can still be hot, allow time for them to cool before touching. |
| - | Keep children and pets away form the |
| + | Keep children and pets away form the DSH whilst in operation. |
| Never disconnect any of the wiring whilst powered on. | |
| - | Be careful of long hair and loose clothing when operating the |
| + | Be careful of long hair and loose clothing when operating the DSH. |
| - | Immediately shut down the |
| + | Immediately shut down the DSH if an error occurs to prevent damage to the unit or its surroundings. |
| == Disclaimer == | |
To undo the changes made by this version, click 'Revert Changes.' This will automatically restore the previous version of this guide.