Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
  1. Mount the Base with the rubber feet to the bottom of the Frame Assembly. Base
    • Mount the Base with the rubber feet to the bottom of the Frame Assembly.

    • Base

    • Rubber Foot

    • M5 x 60 Cap Head Bolt

    • The bolt should thread directly into the bottom of the extrusion.

    • Before mounting the PSU, check that its voltage input is adjusted correctly. The switch on the side of the unit should be set to your mains voltage. For example, in Europe this would be 230v, and in North America it would be 110v.

  2. Mount to the underneath of the Mount to the underneath of the
    • Mount to the underneath of the

Makertech 3D

Member since: 3/9/18

51,265 Reputation

137 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 11

All Time: 687