Stage 05: Raspberry Pi Camera

Written By: Makertech 3D
  • Comments: 1
  • Favorites: 0
  • Completions: 1

Difficulty

Easy

Steps

4

Time Required

00:20:00

Sections

1

Flags

0

  1. Detach the old Pi Cam assembly from the printer and disassemble it. Discard

    • Detach the old Pi Cam assembly from the printer and disassemble it.

    • Discard

    • Keep

    Edit

  2. Drop the Pi cam into the 3d printer case as shown. Secure with the same M2 Nuts and Bolts.

    • Drop the Pi cam into the 3d printer case as shown.

    • Secure with the same M2 Nuts and Bolts.

    Edit

  3. Add an M4 x 6mm bolt and M4 T-nut to the case. Add an M4 x 6mm bolt and M4 T-nut to the case.

    • Add an M4 x 6mm bolt and M4 T-nut to the case.

    Edit

  4. Mount the Pi Cam assembly to the frame as shown. Feed the ribbon cable through the slot on the case. And then through the base.

    • Mount the Pi Cam assembly to the frame as shown.

    • Feed the ribbon cable through the slot on the case.

    • And then through the base.

    • Connect the other end of the ribbon cable to the Raspberry Pi as shown.

    • The blue tab on the cable faces the USB ports.

    Edit
Finish Line

One other person completed this guide.

Author

Makertech 3D

Member since: 03/09/2018

46,775 Reputation

119 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 2

All Time: 262