Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
    • Check your probe assembly:

    • Check you're able to press the stainless steel ball to trigger the switch.

    • Check that the bolts holding the switch in place are secure.

    • Run the cable for the probe down to the base through the beds cable loom.

    • The 4-pin header side of the cable should go into the base.

    • Insert wisdom here

Makertech 3D

Member since: 3/9/18

51,265 Reputation

137 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 16

All Time: 1,010