Proforge 3.5 Upgrade
View
Options
History
1
2
3
4
5
6
7
8
Introduction
Details
Guide Steps
Review
Quiz
Fix the rear panel to the back of the printer with M4 x 6mm bolts and M4 T-nuts a shown.
The panel is not symmetrical. The smaller cut-out goes onto the right side as shown.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.