Step Type:

Drag to rearrange

Cable supports are now available here. See install guide here.

Use cable ties to secure the cable loom to the PTFE tube.

If you are running the default filament sensors, connect their cable to them now and feed them into the braided sleeving.

Use cable ties again to fix the cable loom to the frame as shown - in the production version this part of the bracket points down.

Make sure that there is still enough slack in the cable that the print head can reach the far corners of the printer.

Feed the cable loom into the base and secure with cable ties.

Your contributions are licensed under the open source Creative Commons license.