ProForge 4.2
View
Options
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Introduction
Details
Guide Steps
Review
Quiz
Stick over the aluminium platform plate the magnetic flex-plate sticker.
You may find this sticker, being magnetic, stuck onto the back of the black PEI flexplate in the packaging.
Ensure it is stuck onto the side shown in the images.
Peel away the backing paper from the magnetic sheet. Begin by sticking it to one of the shorter edges pressing it down carefully preventing any air bubbles. Use a credit card to press the sticker down, pushing out any potential air pockets.
After sticking the sheet down use a craft/box knife to cut away where shown to expose the holes. Use a pin to poke through the other side of the plate to make where you should cut.
You don't need to be particularly neat about these cuts, this sticker will have the flexplate go over it.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.