Installed Apps
AXIS 3D Printer
View
Options
History
1
2
3
4
5
6
7
8
Introduction
Details
Guide Steps
Review
Quiz
Begin by threading on two M4 x 8mm bolts onto the top of the tool carriage.
Two M4 x 8mm bolts
Slide the Hotend onto the carriage like shown and tighten the M4 bolts down onto it, clamping it in place.
As you tighten, the hotend may move, push the hotend into its slot to prevent as much of this as possible.
Make sure that the hotend is orientated like shown, with the cables coming out in the direction of the 40mm fan.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.