If your 3D printed tool carriage is like mine and has excess plastic in the sockets for the M3 button heads, be VERY careful trying to dig it out. I managed to crack my part while doing so.
Ok, you note this, “make sure that there is one jumper placed on the UART pins for each axis you have a TMC2208 installed. “ WHICH PINS ARE THE UART PINS?????? You keep leaving little details like this out.
Found the issue. The package detail list shows buttons, but actually contains caps. I was trying to find which bag had these.
If your 3D printed tool carriage is like mine and has excess plastic in the sockets for the M3 button heads, be VERY careful trying to dig it out. I managed to crack my part while doing so.
Are these cap head or button head bolts? The parts bag LRU Bag 2 only has buttons in M3 x 8mm bolts.
IMPORTANT NOTE!! DO NOT INSTALL THESE IF YOU HAVE THE TMC2208 driver UPGRADE!!!! See stage 08 step 18 for details.
Ok, you note this, “make sure that there is one jumper placed on the UART pins for each axis you have a TMC2208 installed. “ WHICH PINS ARE THE UART PINS?????? You keep leaving little details like this out.
I used some painters tape (low tack masking) to hold all the cables together so I could easily feed them into the braid. made it very easy.
33 7/16 inches imperial.
That is 19 11/16 in in Imperial.
Be careful that the zip-tie heads do NOT extend below the belt as that will interfere with the base.
Thank is 39 3/8” in Imperial.
Page 1 of 2
Next