Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
  1. Begin by downloading the following files/software:
    • Begin by downloading the following files/software:

    • Marlin Firmware

    • Touch Screen Firmware

    • USB Drivers

    • PrintRun - Printer Control Software

    • Download All Here

    • The downloads are in a compressed .zip format, you will need to use 7Zip to extract these files on PC.

  2. You will also need to download and install the Arduino IDE.
    • You will also need to download and install the Arduino IDE.

    • Download here.

    • Follow the install instructions and install the Arduino IDE software to your machine.

    • The Firmware has been tested and is working with V1.8.5 of the arduino IDE.

  3. On PC double click on the CH341SER Driver - PC.EXE file. On MAC see the Readme.pdf file in the Mac folder. You may need to right click, "run as admin" to open. Once open, click INSTALL.
    • On PC double click on the CH341SER Driver - PC.EXE file. On MAC see the Readme.pdf file in the Mac folder.

    • You may need to right click, "run as admin" to open.

    • Once open, click INSTALL.

    • Once done, you should get a success message, click OK and close the programme.

  4. Copy the contents of the Touch Screen Firmware folder (depending on whether you're building a Proforge 2 or 2S) to the included SD card. Copy the contents of the Touch Screen Firmware folder (depending on whether you're building a Proforge 2 or 2S) to the included SD card.
    • Copy the contents of the Touch Screen Firmware folder (depending on whether you're building a Proforge 2 or 2S) to the included SD card.

Makertech 3D

Member since: 3/9/18

51,345 Reputation

137 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 10

All Time: 3,051