Torsten Unger

Grmpf, the step of inserting the tubing is definetly too late here! The pressure I had to apply to get is in was sufficinet to change my carefully set nozlle position. Now I have to go through all the steps of adjusting the perfect height again.

Motors Off command does not seem to work.

Pronterface sends M84, however afterwards I can still move all motors with the Pronterface commands

Careful! While testing the X-Motion, I moved the Board to the maximum right (left arrow). it did not stop, it moved until it left the holders and the complete printer was falling to the right side due to the weight (fortunatly I was there to catch it).

I attached the magnets as described - no problem. When I attach the metal sheet with the flexbed surface, I can still move it without efffort on the hotbed. I doubt there is enough adhesion for printing? Probably need additional clips to hold it.

replacements received

Hmmm… no magnets in my pack. I’ll send an email, I’m also missing soomething else.

What is that white ‘blob’ on the flexplate (third picture)? Is that something wrapped? There is nothing like that with my flexplate.