I know, but (as in the case of fixing the linear rails as well), the 10 mm long bolts can not completely screwed inward since they are a little bit too long! I use 8 mm bolts.
Homing Z results a displacement of the printerhead to its maximum value of X and Y, so that the probe is outside the platform. When the platform raises, it pushes to the left ventilator and I have to perform a emergency stop by the power switching off.
I also noticed that the step of 10 mm in X or Y direction is more than 10 mm.
Finally I couldn’t perform the Z homing. And for the same reason I couldn’t perform the Probe Offset.
I found it:
change line in printer.cfg "filename: ~/klipper_config/variables.cfg" to "filename: ~/printer_data/config/variables.cfg"
regards
I got an error:
Internal error during connect: [Errno 2] No such file or directory; '/home/pi/klipper_config/variables.cfg'
Nevertheliess there is a file 'variables.cfg' in /config.
What's wrong?
I also used 6mm long
I know, but (as in the case of fixing the linear rails as well), the 10 mm long bolts can not completely screwed inward since they are a little bit too long! I use 8 mm bolts.
10 mm is a little too long!
10 mm M3 bolts are a few mm too long!
Is there anybody from Makertech with some help or advice?
Homing Z results a displacement of the printerhead to its maximum value of X and Y, so that the probe is outside the platform. When the platform raises, it pushes to the left ventilator and I have to perform a emergency stop by the power switching off.
I also noticed that the step of 10 mm in X or Y direction is more than 10 mm.
Finally I couldn’t perform the Z homing. And for the same reason I couldn’t perform the Probe Offset.
Nowhere in this manual I can find where the blue-yellow-green-red wires must be connected on the board! Have they no use? Please explain…
Indeed, here also…