Editing Step 3 —

Step Type:

Drag to rearrange

Next, remove the tool carriage and Y-belt from the gantry. Do not cut the belt, it will be re-used.

Free the y-endstop from the gantry.

The lead screw bracket at the top of the printer can also be removed, this part can be disregarded as it won't be re-used.

Disconnect the y-motor from its cable.

Use side cutters to break the cable ties holding the cables to the gantry.

Free the lead screw coupling from the z-motor shaft.

Finally remove the HDPE linear guides from the gantry and the entire gantry part should now be free.

Your contributions are licensed under the open source Creative Commons license.