Same Problem Now....
I have to set all 4
switch_pin: ^!PF4
to
switch_pin: ^PF4
no "!"
16.12.2024
I have the same problem.
Thanks for the link ...
the gliders run well
though the rails have some deep necks...
I stopped the project!
two of the 3 old linear rails (sliders) no longer run well ...
"Take the four long 2020 extrusions that you drilled the holes in earlier."
????
"Mechanical 2020 458mm Extrusion 5mm hole 10mm from both sides 4x"
No holes, when should I have drilled them?
Markus Carls
91 mm is better and make a cylinder on the entrance side with a knife….
no information about the "P3 DD Fan Shroud"
torn the first time you put it on... !
in "3D Printed Parts ST" only as
"P3 DD Fan Shroud (mirror for other side).STL"
missing “the metal fan and probe mount”
in "DSH-BAG A"
M3 x 8mm bolts and
M5 nut
I have here "M5 x 20mm Bolt" in "DSH-BAG A"
and an extra "BAG" with
2x "Thrust Bearing" and
1x "Shim”…..
Page 1 of 2
Next
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
Same Problem Now....
I have to set all 4
switch_pin: ^!PF4
to
switch_pin: ^PF4
no "!"
16.12.2024
I have the same problem.
Thanks for the link ...
the gliders run well
though the rails have some deep necks...
I stopped the project!
two of the 3 old linear rails (sliders) no longer run well ...
"Take the four long 2020 extrusions that you drilled the holes in earlier."
????
"Mechanical 2020 458mm Extrusion 5mm hole 10mm from both sides 4x"
No holes, when should I have drilled them?
Markus Carls
91 mm is better and make a cylinder on the entrance side with a knife….
no information about the "P3 DD Fan Shroud"
torn the first time you put it on... !
in "3D Printed Parts ST" only as
"P3 DD Fan Shroud (mirror for other side).STL"
missing “the metal fan and probe mount”
in "DSH-BAG A"
M3 x 8mm bolts and
M5 nut
I have here "M5 x 20mm Bolt" in "DSH-BAG A"
and an extra "BAG" with
2x "Thrust Bearing" and
1x "Shim”…..
Page 1 of 2
Next