My touchscreen is broken (form submitted), so I can’t do the Z-axis test from there, however I’ve tested both via OctoPi and Ponteface and my Z-axis won’t move at all (not even a peep from the motors).
Checked:
- Jumpers are installed
- Red stepper is correct
- The parallel joiner is correct (red wires the same on both ends)
- Tried flashing the firmware again and still no love
- Z-axis probe works fine
- When off, the Z-axis motors twist and the gantry moves freely
Save re-cabling later, I have installed the stepper motor and driver for the DSE setup - would this be impacting? If not, any ideas as to what’s wrong?
My touchscreen is broken (form submitted), so I can’t do the Z-axis test from there, however I’ve tested both via OctoPi and Ponteface and my Z-axis won’t move at all (not even a peep from the motors).
Checked:
- Jumpers are installed
- Red stepper is correct
- The parallel joiner is correct (red wires the same on both ends)
- Tried flashing the firmware again and still no love
- Z-axis probe works fine
- When off, the Z-axis motors twist and the gantry moves freely
Save re-cabling later, I have installed the stepper motor and driver for the DSE setup - would this be impacting? If not, any ideas as to what’s wrong?