ProForge 4
View
Options
Preview new Authoring Experience
History
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
Introduction
Details
Guide Steps
Review
Quiz
Rename the klipper.bin file to firmware.bin
Take the micro SD card that came with the Octopus MAX control board and copy onto it the firmware.bin file.
With the printer powered off:
Insert the SD card into the Octopus Max control board as shown.
Disconnect the USB cable that goes to the control board from the Pi.
Power on to flash the board
Wait a few minutes and then plug the USB cable back into the board.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.