Editing Step 26 —
Motor Checks X/Y

Step Type:

Drag to rearrange

Manually move the tool head to roughly the centre of the print area. Also make sure that the platform is not set all the way to the top or bottom, but somewhere safe in the middle.

Send the command: STEPPER_BUZZ STEPPER=stepper_x

This will move the front left and rear right motors clockwise by a small amount and then return it to its original position. It will do this several times.

Send the command: STEPPER_BUZZ STEPPER=stepper_y

This will move the rear left and front right motors anti-clockwise by a small amount and then return it to its original position. It will do this several times.

If the above described movements do not occur, power down and double check you wiring.

Your contributions are licensed under the open source Creative Commons license.