You should take about 1,15m of sleeving. Both hot ends (Dual Hotend) were about 15cm shorter as expected so I had to “extend” the sleeving afterwards with an additional sleeving part overlapping slightly.
As this part is not inside the “06 Gantry” bag it should be pointed out where it can be found and/or a photo of it NOT assembled with the other parts should be shown!
I heard about the TMC2100 doesn’t need the jumpers. Is it true? Should I take them off or doesn’t it make a difference?
This position definitely doesn’t work when using the dual head… I had two crashes into the camera and so I put it aside.
I had to use two small washers (spare parts) to not screw inside the cable connector.
@Phil: I was also thinking that… ;)
You should take about 1,15m of sleeving. Both hot ends (Dual Hotend) were about 15cm shorter as expected so I had to “extend” the sleeving afterwards with an additional sleeving part overlapping slightly.
Bearing - 685ZZ ??
As this part is not inside the “06 Gantry” bag it should be pointed out where it can be found and/or a photo of it NOT assembled with the other parts should be shown!
The M5 T-Nuts are in another package. It has ”Other Fasteners” on it. The yare not in the “Stage 1: Base” package.