Page 1 of 2
Next
I buy a new MG90S Servo, and replaced old one that didn’t move anymore.
But when I press Select T1 or Select T0 on Touch screen, it just move about 15 degree.
What should I do ?
Me too.
I start printing the Calibration Model.
And when it switch 2 times.
It don't change anymore.
Even I restart printer.
It doesn't move anymore.
When I set temperature both head are rising.
Is that right?
I thought that supposed it should rising independently,am I got wrong idea?
How to determine Hotend configuration High / High Or Low / High?
Do you means the “Heatsink Fans“ in Step 9 ?
The only 2 M3 x 6mm used on Stage 02: Extruders, so there's no more M3 x 6mm for this step
My heater block's crack open on wrong side…
There's no red wire's connector in package…
no M4 x 10mm threaded spacers in the package,too
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
I buy a new MG90S Servo, and replaced old one that didn’t move anymore.
But when I press Select T1 or Select T0 on Touch screen, it just move about 15 degree.
What should I do ?
Me too.
I start printing the Calibration Model.
And when it switch 2 times.
It don't change anymore.
Even I restart printer.
It doesn't move anymore.
When I set temperature both head are rising.
Is that right?
I thought that supposed it should rising independently,am I got wrong idea?
How to determine Hotend configuration High / High Or Low / High?
Do you means the “Heatsink Fans“ in Step 9 ?
The only 2 M3 x 6mm used on Stage 02: Extruders, so there's no more M3 x 6mm for this step
My heater block's crack open on wrong side…
There's no red wire's connector in package…
no M4 x 10mm threaded spacers in the package,too