Help
Sven Haiges
@hansamann
Sven Haiges
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 03/27/2019 | |
Maker at heart.
| 1 | Reputation |
|---|---|
| 0 | Guides |
| Member Since 03/27/2019 | |
Maker at heart.
The download link does not work.
I had 3 jumpers left and underneath the 4th ring in the picture there is another set of pins - I connected these with the remainign jumpers. Is this OK?
Unfortunately I have a severe problem here… I do not have two M5 T-Nuts left. Luckily I bought the dual extruder and after searching in these boxes, I found a few more. Is this intentional? I have quite a few other screws and bits left over, but the T-Nuts are scarce…
So I have a 2S - two support beams - I hope at this point I did not have to attach the second beam already. A little notice that it’s OK would be nice.
It’s in Box B
A picture of how that fasteners pack looks like would help :-)