Make sure you stand the printer up right, on a flat, level surface before doing this part. Hold the platform down, such that all four linear bearings are in contact with the base. Then tighten the screws in a star pattern (like changing a tire), starting with the outside four, and finishing with the inside four.
Put the switch on the underside of the screen in the left position to correctly orient the screen on boot up.
The two commands here should be four commands...
cd ~/
git clone............
and:
cd ~/
./scripts/...........
Clumped together like they are gives an error, and people that are inexperienced with Linux will struggle here.
My backplate wasn't drilled deep enough. I had to add 1mm washers between the bolt head and servo.
How is the bed wire-management accomplished?
Be careful, these are VERY easy to stip out. Only tighten them until there is resistance.
Also, remove the z shaft brackets. Discard shafts and brackets.
Need to remove the lead screws too.
Make sure you stand the printer up right, on a flat, level surface before doing this part. Hold the platform down, such that all four linear bearings are in contact with the base. Then tighten the screws in a star pattern (like changing a tire), starting with the outside four, and finishing with the inside four.
Yes. Teeth inward for the whole loop. This instruction should be updated.
So to me, it looks like the inside of the loop should be the tooth'd side… not the smooth side. Am I misunderstanding something here?
Page 1 of 2
Next